当前位置:
微型减速电机的调速器该怎样进行安装
回复 | 人气 | 打印
榜眼探花 个人主页 给TA发消息 加TA为好友 发表于:2020-01-11 10:17:01 楼主

  微型减速电机是将直流电能转化为机械能或机械能转化为直流电能的旋转电机。本应与其调速器接触,由于其具有低噪声、省电等特点,在工业上得到了广泛的应用,其效果直接影响到微型减速电机调速器的使用。

  1.接通交流电源线,按正、负压接通励磁电压,否则会造成反转。

  2.在主枢电路的输出端,+极连接到微型减速电机主枢的正极,-极连接到主枢的负极。

  3.测速反馈+极连接到测速发电机反馈信号的正极,测速反馈极连接到测速发电机反馈信号的负极。

  4.将微型减速电机底盘放在通风良好、无腐蚀性气体的地方,检查内部螺钉是否因运输而松动。

  5.操作前手动将面板上的电位器调整到零,然后给电源供电,然后旋转手动电位器旋钮。

  微型减速电机

  Micro deceleration motor is a rotating motor which can convert DC electric energy into mechanical energy or mechanical energy into DC electric energy.

  We should have come into contact with its governor, because of its low noise, power saving and other characteristics, it is widely used in industry, and the result directly affects the use of DC motor governor.

  1.Connect the AC power cord and press positive or negative to connect the excitation voltage, otherwise it will cause reversal.

  2.At the output end of the main armature circuit, the + pole is connected to the positive pole of the main armature of the DC motor, and the-pole is connected to the negative pole of the main armature.

  3.The speed measuring feedback + pole is connected to the positive pole of the feedback signal of the speed measuring generator, and the speed measuring feedback-pole is connected to the negative pole of the feedback signal of the speed measuring generator.

  4.Place the miniature deceleration motor chassis in a place with good ventilation and no corrosive gas.Check to see if the internal screws are loose due to transportation.

  5.Manually adjust the potentiometer on the panel to zero before operation.Then supply the power supply voltage, and then rotate the manual potentiometer knob.

分享到: 关注收藏 邀请回答 回复 举报


周点击排行
周回复排行
最新求助