尊敬的各位达人,求助POMINI磨床的2个故障:
1、关于涡流探伤,详情请见图片。
2. 关于检测砂轮的A探头的问题,在开始磨削,界面显示初始化时,开始报警“67000 Wheel probe proximity fault
PLC input
Electrical drawing
200.7
Explanation
During wheel approach the CNC has received a fault signal from the probe.
The control is done on the proximity S2007 that at the cycle begin must be normally high=1. When the probe arrives to 10 mm from the roll the proximity status becomes normally low = 0. If these conditions are not satisfied, this alarm will appear.
Alarm active
During wheel approach
Remedy
Clean the probe face in order to remove all iron slag from the proximity switches.
Check the proximity S2007 (the largest on the probe) for proper operation.
It is possible to reset the alarm with the "Cancel" pushbutton
”
请各位达人指点迷津,这2个问题困扰我很久了,谢谢!