How to Configure the Server Side • Register you component • Open the dcomcnfg tool • In the Applications tab, select your application, Click on Properties… button • Properties -> General tab -> Authentication Level combo box. Select Default. • Properties -> Location tab. Select Run application on this computer. • Properties -> Security tab. Select Use custom access permissions option box, click on Edit button, and then click on Add button to add the following users (Allow Access): o Rebat Hiary • Properties -> Security tab. Select Use custom launch permissions option box, click on Edit button, and then click on Add button to add the following users (Allow Launch): o Rebat Hiary o PC2/Administrators o System o Interactive • Properties -> Security tab. Select Use custom configuration permission option box, click on Edit button, and then click on Add button to add the following users: o Naim Tobassi o Rebat Hiary o Everyone o System o Owner creator o PC2/Power Users o PC2/Administrators • Properties -> Identity tab. Select The interactive user option box. • Click on OK button to return back to the Distributed COM Configuration Properties window. • Default Properties tab. Select Enable Distributed Com on this computer check box. • Default Properties tab -> Default Authentication Level combo box. Select Connect. • Default Properties tab -> Default Impersonation Level combo box. Select Anonymous. • Default Security tab. On the Default Access Permission frame click on Edit Default… button, and add the following users (Allow Access): o Everyone o Rebat Hiary • Default Security tab. On the Default Launch Permission frame click on Edit Default… button, and add the following users (Allow Launch): o Everyone o Interactive o PC2/Administrators o System o Rebat Hiary • Default Security tab. On the Default Configuration Permissions frame click on Edit Default… button, and add the following users: o Naim Tobassi o Everyone o System o Creator Owner o PC2/Power Users o PC2/Administrators